|
|
SRS 100-A4
New Product Introduction - August 2003
Units installed since introduction as of September 1, 2003 = 57 units in North America
Getecha SRS 100-A4 Micro-molding granulator
A small footprint at a small price!
Technical data:
Cutting diameter: 4" / 100 mm
Inlet width: 2.35" X 3.15" / 60 x 80 mm
Cutting length: 4" / 100 mm
Footprint: 10.5" X 21.5"
Feed height: 19.6" as shown
Screen perforation: 4.5 mm round, angled perforation
Throughput: 17.5 lbs/hr / 8 kgs/hr
Rotor revolution: approx. 220 r.p.m.
Load: 1 HP
|
 |
Main features are:
small footprint
stainless steel
suitable for clean room
low infeed height
low maintenance
low cost <$4,000
Typical runners
 |
Applications:
The SRS 100-A4 is designed for micro-molding applications. The SRS 100-A4 is designed to be fed small runners, one at a time, from injection molding machines up to 40-50 tons. Regrind should be evacuated back to the hopper loader on a consistent basis. If runner weight or percentage exceeds the re-usable percentage, an alternative, optional discharge device is offered to address these instances.
|
Getecha can also provide a complete system consisting of the granulator, proportioning valve, timer, and all necessary hosing and clamps to run in-line with an existing loading system.
|
